Procom FBD28T Installationshandbuch PDF herunterladen (Seite 7)

www.usaprocom.com

7200014-01A

AIR FOR COMBUSTION AND VENTILATION

WARNING: This heater shall

not be installed in a conned space

or unusually tight construction

unless provisions are provided

for adequate combustion and

ventilation air. Read the following

instructions to insure proper fresh

air for this and other fuel-burning

appliances in your home.

Today’s homes are built more energy efcient

than ever. New materials, increased insulation

and new construction methods help reduce

heat loss in homes. Home owners weather

strip and caulk around windows and doors

to keep the cold air out and the warm air in.

During heating months, home owners want

their homes as airtight as possible.

While it is good to make your home energy

efcient, your home needs to breathe. Fresh

air must enter your home. All fuel-burning ap-

pliances need fresh air for proper combustion

and ventilation.

Exhaust fans, replaces, clothes dryers and

fuel burning appliances draw air from the house

to operate. You must provide adequate fresh

air for these appliances. This will insure proper

venting of vented fuel-burning appliances.

PROVIDING ADEQUATE VENTILATION

The following are excerpts from National Fuel

Gas Code, ANSI Z223.1/NFPA 54, Air for

Combustion and Ventilation.

All spaces in homes fall into one of the three

following ventilation classications:

1. Unusually Tight Construction

2. Unconned Space

3. Conned Space

The information on pages 7 through 9 will help

you classify your space and provide adequate

ventilation.

Unusually Tight Construction

The air that leaks around doors and windows

may provide enough fresh air for combustion

and ventilation. However, in buildings of un-

usually tight construction, you must provide

additional fresh air.

Unusually tight construction is dened as

construction where:

a. walls and ceilings exposed to the outside

atmosphere have a continuous water

vapor retarder with a rating of one perm

(6 x 10

-11

kg per pa-sec-m

2

) or less with

openings gasketed or sealed and

b. weather stripping has been added on

openable windows and doors and

c. caulking or sealants are applied to areas

such as joints around window and door

frames, between sole plates and oors,

between wall-ceiling joints, between wall

panels, at penetrations for plumbing, elec-

trical and gas lines and at other openings.

If your home meets all of these three criteria,

you must provide additional fresh air. See

Ventilation Air From Outdoors, page 9.

If your home does not meet all of the three

criteria above, proceed to Determining Fresh-

Air Flow For Heater Location, page 8.

Conned and Unconned Space

The National Fuel Gas Code, ANSI Z223.1/

NFPA 54 denes a conned space as a space

whose volume is less than 50 cubic feet per

1,000 Btu/hr (4.8 m

3

per kw) of the aggregate

input rating of all appliances installed in that

space and an unconned space as a space

whose volume is not less than 50 cubic feet per

1,000 Btu/hr (4.8 m

3

per kw) of the aggregate

input rating of all appliances installed in that

space. Rooms communicating directly with the

space in which the appliances are installed*,

through openings not furnished with doors, are

considered a part of the unconned space.

* Adjoining rooms are communicating only if

there are doorless passageways or ventilation

grills between them.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare