Procom MD300HGA Spezifikationen PDF herunterladen (Seite 17)

INSTALLING LOGS

Fig. 13 - Installing Log Set

IMPORTANT: Make sure log does not cover any

burner ports (see Fig. 13). It is very important

to install the logs exactly as instructed. Do not

modify logs. Use only logs supplied with heater.

STEP 1: Install log 1 onto the two slots in

middle plate.

All logs

STEP 2: Install log 2 onto the two slots

in left plate.

STEP 3: Install log 3 onto the two slots

in right plate.

WARNING: Failure to position the parts

in accordance with these diagrams or failure

to use only parts specically approved with

this heater may result in property damage

or personal injury.

CAUTION: After installation, and

periodically thereafter, check to ensure that no

ame comes in contact with any log. With the

heater set to high, check to see if ames

contact any log. If so, reposition logs

according to the log installation instructions

in this manual. Flames contacting logs will

create soot.

Burner Ports Log Set

STEP 4: Install the recessed hole on the

bottom of log 4 onto the pin on

log 1 and place on log 2

STEP 5: Install the recessed hole on the

bottom of log 5 onto the pin on log 1

and place on log 3

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Keine Kommentare

Procom MD300HGA Spezifikationen Seite 17