Procom MD300HGA Spezifikationen PDF herunterladen (Seite 7)

UNPACKING

1. Remove top inner pack.

2. Tilt carton so that heater is upright.

3. Remove protective side packaging.

4. Slide heater out of carton.

5. Remove protective plastic wrap.

6. Remove screw at top of screen.

7. Hold the screen, lift, and pull forward.

8. Remove log set by cutting plastic ties.

9. Carefully unwrap log.

10. Check for any shipping damage. If heater or log is damaged, promptly inform your dealer

where you bought the heater.

WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS

Water vapor is a by-product of gas combustion. An unvented room heater produces

approximately one (1) ounce (30 mL) of water for every 1,000 BTUs (.3 kw) of gas input

per hour. An unvented room heater is recommended as a supplemental heater (a room)

rather than a primary heat source (an entire house). In most supplemental heat

applications, the water vapor does not create a problem. In most applications, the water

vapor enhances the low humidity atmosphere experienced during cold weather.

The following steps will help ensure that water vapor does not become a problem:

1. Be sure the heater is the proper size for the application, including adequate

combustion air and circulation air.

2. If there is high humidity, a dehumidier may be used to help lower the water vapor

content of the air.

3. Do not use an unvented room heater as the primary heat source.

Fig. 1

Mantel

Screen

Logs

Heater Controls

(Behind Panel)

Screw

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Keine Kommentare

Procom MD300HGA Spezifikationen Seite 7