Procom FBD28T Installationshandbuch PDF herunterladen (Seite 18)

www.usaprocom.com

200014-01A18

OPERATION

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly, a

re or explosion may result caus-

ing property damage, personal

injury or loss of life.

A. This appliance has a pilot which must

be lighted by hand. When lighting the

pilot, follow these instructions exactly.

B. BEFORE LIGHTING smell all around

the appliance area for gas. Be sure to

smell next to the oor because some

gas is heavier than air and will settle

on the oor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do

not use any phone in your building.

• Immediately call your gas supplier

from a neighbor’s phone. Follow the

gas supplier’s instructions.

• If you cannot reach your gas supplier,

call the re department.

C. Use only your hand to push in or turn

the gas control knob. Never use tools.

If the knob will not push in or turn

by hand, don’t try to repair it, call a

qualied service technician. Force or

attempted repair may result in a re or

explosion.

D. Do not use this appliance if any part

has been under water. Immediately call

a qualied service technician to inspect

the appliance and to replace any part of

the control system and any gas control

which has been under water.

BATTERY INSTRUCTIONS

CAUTION: Do not mix old and

new batteries. Do not mix alka-

line, standard (carbon - zinc), or

rechargeable (nickel - cadmium)

batteries. Do not dispose of

batteries in re, batteries may

explode or leak.

• Batteries are included.

• Remove batteries when depleted.

• Install/replace the batteries according to the

type and quantity stated in table below.

• Be sure to observe proper polarity (+/-)

when installing or replacing the batteries.

Damage due to improper battery installation

may void the warranty on the product.

• For remote control systems, maximize bat-

tery life by turning off the receiver when it

is not in use.

• For long periods of non-operation, remove

batteries from all components for safety.

Unscrew ignitor cap and install a AAA battery

with the + pointing out. Replace cap.

Figure 20 - Installing Battery in Ignitor

AAA

Battery

Positive

UP

INSTALLATION

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare