Procom FBD28T Spezifikationen PDF herunterladen (Seite 18)

OPERATION

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a re or explosion may result causing property damage, personal

injury, or loss of life.

NOTICE: During initial operation of new heater, burning logs will give off a paper burning smell. Orange ame will also be

present. Open a window to vent smell. This will last only a few hours.

CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.

A. This appliance has a pilot which must be lit by the electronic ignitor. When lighting the pilot, follow these instructions exactly.

B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the oor because some gas is

heavier than air and will settle on the oor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the re department.

C. Use only your hand to push control. Never use tools. If the appliance does not operate, don’t try to repair it. Call a qualied

service technician or gas supplier. Forced or attempted repair may result in a re or explosion.

D. Do not use this appliance if any part has been under water. Immediately call a qualied service technician to inspect the

appliance and to replace any part of the control system and any gas control, which has been under water.

Note: Please wait one minute after shutting off replace to allow the control valve to reset before starting again.

LIGHTING INSTRUCTIONS

Unscrew ignitor cap and install a AAA battery with the + pointing out. Replace cap.

1. STOP! Read the safety information on page 18.

2. Warning: You must operate this heater with the screen in place. Make sure screen is installed before running heater.

3. Turn control knob clockwise to the OFF position, see Fig. 19, page 19.

4. Wait ve (5) minutes to clear out any gas. Then smell for gas around heater and near oor. If you smell gas, STOP! Follow

"B" in the safety information on Warnings plate. If you don't smell gas, go to the next step.

5. Turn control knob counterclockwise to the PILOT position. Keep control knob pressed in for ve (5) seconds. Note: You may

be running this heater for the rst time after hooking up to gas supply. If so, the control knob may need to be pressed in for

30 seconds. This will allow air to bleed from the gas system. If control knob does not pop up when released, contact a

qualied service person or gas supplier for repairs.

6. With control knob pressed in, push down and release ignitor button. This will light pilot.The pilot is attached to the rear of

the front burner. If needed, keep pressing ignitor button until pilot lights. Note: If pilot does not stay lit, contact a qualied

service person or gas supplier for repairs. Until repairs are made, light pilot with match.

7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Note: If pilot goes

out, repeat steps 3 through 7. This heater has a safety interlock system. Wait one (1) minute before lighting pilot again.

8. WARNING: Make sure that while the input gas type is NG, pilot burner NG ignites; while the input type is LP, pilot burner LP

ignites. Note: If you nd anything abnormal in this step, repeat steps 2 through 8.

9. Turn control knob counterclockwise to the desired heating level. The main burner should light. Set control knob to any heat

level between HI and LO (5 –1).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Keine Kommentare

Procom FBD28T Spezifikationen Seite 18