Procom FBD28T Spezifikationen PDF herunterladen (Seite 19)

THERMOSTATIC CONTROL OPERATION

The thermostatic control used on this model differs from standard thermostats. Standard thermostats simply turn the burner on

and off. The thermostat used on this heater senses the room temperature. At times the room may exceed the set temperature.

If so, the burner will shut off. The burner will cycle back on when room temperature drops below the set temperature. The

control knob can be set to any comfort level between HIGH (5) and LOW (1).

Note: The thermostat sensing bulb measures the temperature depending on housing construction.

TO TURN OFF GAS TO APPLIANCE

Shut off heater.

Turn Control Knob clockwise to the OFF position. Do not force.

MANUAL LIGHTING PROCEDURE

(Match light)

1. Remove screen by lifting and pulling forward.

2. Follow steps 1 through 5 under Lighting Instructions.

3. With control knob in PILOT position, strike match, and

hold near pilot. Press in control knob; pilot should light.

4. Keep control knob pressed in for 30 seconds after lighting

pilot. After 30 seconds, release control knob.

5. Make sure the heater screen is in place before operating heater.

Fig. 19 - Control Knob Position

Ignitor

Control Knob

• Batteries are included.

• Remove batteries when depleted.

• Install/replace the batteries according to the type and quantity stated in table below.

• Do not mix old and new batteries. New batteries should be the same brand for best results.

• Be sure to observe proper polarity (+/-) when installing or replacing the batteries. Damage due to improper battery

installation may void the warranty on the product.

• For remote control systems, maximize battery life by turning off the receiver when it is not in use.

• For long periods of non-operation, remove batteries from all components for safety.

BATTERY INSTRUCTIONS

Component Type of Battery Battery Qty.

Ignitor AAA 1

Remote Control AAA 2 or 3*

Remote Receiver AA 4

*Note: Quantity depends on model of remote control.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Keine Kommentare

Procom FBD28T Spezifikationen Seite 19