Procom PCD18T Installationsanleitung PDF herunterladen (Seite 17)

INSTALLING LOGS

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts

specically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically thereafter, check to ensure that no yellow flame comes in

contact with any log. With the heater set to High, check to see if yellow flames contact any log. If so,

reposition logs according to the log installation instructions in this manual. Yellow ames contacting logs will

Provided Logs: 7

create soot. It is very important to install the logs exactly as

instructed. Do not modify logs. Use only logs supplied with

heater.

Each log is marked with a number. This number will help you

to identify the logs when installing. It is very important to install

these logs exactly as instructed. Do not modify logs.

After installing logs, add decorative cinders around the grate

base, do not place any decorative cinders on logs or burner.

1. Insert log #1 into slots in rear log

bracket on grate base, and tighten

nuts.

Figure 27 - Installing Log #2

Figure 28 - Installing Log #3&Log#4

Figure 29 - Installing Log #5

Figure 31 - Installing Log #7

Figure 30 - Installing Log #6

5. Insert the recessed hole on the

bottom of log #5 onto pin on log #1,

with the other end placed on log #2.

6. Insert the recessed hole on

the bottom of log #6 onto pin on

log #2, with the other end placed

on log #3.

3. Insert log #3 and log#4 into slots

in front log bracket on grate base

and tighten nuts.

2. Insert log #2 into slots in middle

grate bracket and tighten nuts.

Figure 26 - Installing Log #1

PCD24M & PCD24TD

6. Insert the recessed hole on

the bottom of log #7 onto pin on

log #2, with the other end placed

on log #4.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Keine Kommentare

Procom PCD18T Installationsanleitung Seite 17