Procom PCD18T Installationsanleitung PDF herunterladen (Seite 8)

WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS

Water vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1) ounce

(30ml) of water for every 1,000 BTUs (.3KWs) of gas input per hour. Unvented room heaters are recommended

as supplemental heat (a room) rather than a primary heat source (an entire house). In most supplemental heat

applications, the water vapor does not create a problem. In most applications, the water vapor enhances the low

humidity atmosphere experienced during cold weather.

The following steps will help insure that water vapor does not become a problem.

1. Be sure the heater is sized properly for the application, including ample combustion air and circulation air.

2. If high humidity is experienced, a dehumidier may be used to help lower the water vapor content of the air.

3. Do not use an unvented room heater as the primary heat source.

WARNING: A qualied technician must install heater. Follow all local codes.

WARNING: Before installing in a solid ue burning rebox, the chimney ue and rebox must be cleaned of

soot, creosote, ashes and loose paint by a qualied chimney cleaner. Creosote will ignite if highly heated. A

dirty chimney ue may create and distribute soot within the house. Inspect chimney ue for damage.

WARNING: Maintain the minimum clearances.

If possible, provide greater clearances from the

oor, ceiling, and adjoining wall than required.

Minimum Fireplace Clearance to Combustible Materials

Log size Side wall Ceiling

18 in, 24 in 16 in. 42 in.

PREPARING FOR INSTALLATION

Before beginning assembly or operation of the product, make sure all parts are present. Compare parts with

package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install

or operate the product. Contact customer service for replacement parts.

Estimated Assembly Time: 1 to 2 hours

Tools Required for Assembly:

Before installing heater, make sure you have the items listed below

• Hardware package (provided with heater)

• Approved exible gas hose (not provided) if allowed by local codes

• Sealant (resistant to natural or propane/LP gas, not provided)

• Electric drill with 3/16” drill bit

• Phillips screwdriver

• External regulator (supplied by installer)

• Piping (check local codes)

• Equipment shutoff valve

• Test gauge connection

• Sediment trap

• Tee joint

• Pipe wrench

UNPACKING

1. Remove logs and burner base assembly from carton. NOTE: Do not pick up burner base assembly by burn-

ers as this could damage heater. Always handle base assembly by grate.

2. Remove all protective packaging applied to logs and heater for shipment.

3. Check all items for any shipping damage. If damaged, promptly inform dealer where you purchased the

heater.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare

Procom PCD18T Installationsanleitung Seite 8

Kommentare zu diesen Handbüchern