Procom PCD18T Installationsanleitung PDF herunterladen (Seite 9)

A. Clearance from the side of the replace opening to any combustible material and wall should follow diagram in

Figure 4.

B. Clearance from the top of the replace opening to the ceiling must not be less than 42 inches.

MINIMUM NONCOMBUSTIBLE MATERIAL CLEARANCE

If Not Using Mantel

You must have noncombustible material(s) above the replace opening. Noncombustible materials (such as slate, mar-

ble, tile, etc.) must be at least 1/2 inch thick. With sheet metal, you must have noncombustible material behind it, such as

a noncombustible replace hood accessory. See Figure 5 next page for minimum clearance requirements.

WARNING: Seal any fresh air vents or ash clean-out doors located on the oor or wall of replace to prevent

drafting caused by pilot outage or sooting. Use a heat-resistant sealant. Do not seal chimney ue damper.

CAUTION: This heater creates warm air currents. These currents move heat to wall surface next to heater. Install-

ing heater next to vinyl or cloth wall coverings or operating heater where impurities (such as tobacco smoke,

aromatic candles, cleaning uids, oil or kerosene lamps, etc.) in the air exist may discolor walls.

NOTICE: State or local codes may only allow operation of this appliance in a vented conguration. Check your

state or local codes.

NOTICE: This heater is intended for use as supplemental heat. Use this heater along with your primary heating

system. Do not install this heater as your primary heat source. If you have a central heating system you may run

the system’s circulating blower while using the heater. This will help circulate the heat throughout the house. In the

event of power outage, you can use this heater as your primary heat source.

IMPORTANT: Vent-free heaters add moisture to the air. Although this is benecial, installing heater in rooms

without enough ventilation air may cause mildew to form from too much moisture. See Air for Combustion and

Ventilation, pages 5 through 7.

WARNING: This appliance is designed

for installation in only a solid-fuel burn-

ing masonry or UL 127 factory-built

replace or in a listed ventless rebox

enclosure. Exception: DO NOT install

LOG SIZING REQUIREMENTS

Log Size Minimum Firebox Size

High Depth Front Width Rear Width

PCD18T 20 in. 13 in. 29 in. 23 in.

PCD24TD 20 in. 14 in. 30 in. 24 in.

PCD24M 20 in. 14 in. 30 in. 24 in.

CHECK GAS TYPE

Make sure your gas supply is correct for

your log set. If supply is not correct, do

not install heater. Call dealer where you

purchased heater for proper gas log set.

this appliance in a factory-built replace

that includes instructions stating it has

not been tested or should not be used

with unvented gas logs.

MINIMUM CLEARANCE FOR SIDE

Combustible Material, Side Wall, and

Ceiling.

Figure 4 - Minimum Clearance for Combustible to Wall

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare

Procom PCD18T Installationsanleitung Seite 9

Kommentare zu diesen Handbüchern